Non-Silicone Tooling Rubber

DESCRIPTION:
CUREPAD is a "B-staged" non-silicone rubber that can be formed into complex shapes to assist in the even application of pressure on assemblies. CUREPAD should be used where normal bagging procedures cause difficulty in preventing bridged conditions. CUREPAD can also be used where normal bagging procedure could cause unwanted mark off on the assembly.

CUREPAD is a not a silicone product and requires a release media between the rubber and the assembly being cured. Normal mold release products work well with Curepad.

APPLICATION:
CUREPAD should be used where it can assist in the even distribution of cure pressure and where a high quality surface is necessary. CUREPAD can be used many times after the material has been formed to the desired shape during the initial cure of the CUREPAD assembly. CUREPAD can be used as pads for tooling pins, sharp edges, etc. Interleaving with a fiberglass cloth during the initial CUREPAD forming cure can increase the durability of CUREPAD as well as reduce the effects of shrinkage during subsequent cures.

PHYSICAL PROPERTIES:

Note: Data provided is for information only and does not constitute any warranty for the product. As the conditions and varying methods of use are beyond our control, Richmond Aircraft Products, Inc. shall not be liable for any special, indirect, incidental, or consequential damages, including without limitation, lost revenues or lost profits, which may result from the use, or inability to use these materials. These materials are provided "as is" without warranty of any kind, either expressed or implied, including, but not limited to the implied warranties of merchantability or fitness for a particular purpose.