Non-Silicone Tooling Rubber
DESCRIPTION:
CURETAPE 127 is a "B-staged" non-silicone rubber that can be formed into complex shapes to assist in the even application of pressure on assemblies. CURETAPE 127 should be used where normal bagging procedures cause difficulty in preventing bridged conditions.
CURETAPE 127 is a not a silicone product and requires a release film between the rubber and the assembly being cured.
APPLICATION:
CURETAPE 127 should be used to minimize bridging problems and provide even distribution of cure pressure where a high quality surface is necessary. CURETAPE 127 is not intended to be a reusable system. CURETAPE 127 can be used as pads for tooling pins, sharp edges, etc.
PHYSICAL PROPERTIES:
|
Standard thickness:
Standard widths:
Roll length:
Maximum cure temperature: |
.125"
.750" and 1.00"
25'/rl.
>175°F |
3.17mm
19 mm and 25.4 mm
7.6 m
49°C |
NOTE: Shelf life limitations apply.
Note: Data provided is for information only and does not constitute any warranty for the product. As the conditions and varying methods of use are beyond our control, Richmond Aircraft Products, Inc. shall not be liable for any special, indirect, incidental, or consequential damages, including without limitation, lost revenues or lost profits, which may result from the use, or inability to use these materials. These materials are provided "as is" without warranty of any kind, either expressed or implied, including, but not limited to the implied warranties of merchantability or fitness for a particular purpose. | 
