Excess Flash Absorbent Composite
DESCRIPTION:
FLASHSORB is a high temperature (400°F / 205°C) material suitable for most adhesive bond and co-cure assembly applications. FLASHSORB is a composite of Richmond's peel-ply, breather/bleeder and release film. Flashsorb is custom constructed to the customers needs and is normally used in 2 inch to 6 inch wide tapes however, wide width FLASHSORB is available.
APPLICATION:
FLASHSORB is a multi-layered composite material designed to absorb excess adhesive/resin flash from flash line areas or assemblies and when stripped, leaves a virtually "clean-up free" flash line area.
CONSTRUCTION:
All FLASHSORB is custom made to customers needs. FLASHSORB ordering as follows:
(Example) 61 07 E 6 15
MATERIAL IDENTIFIERS:
|
Peel Plies:
Breather:
Release film: |
59 = 51789
61 = 60001
62 =60002
04 = A3000 4
07 = A3000 7
10 = RC-3000-10
10B = RC-3000-10B
02 = 4819
E = E3760 or EP = E3760 perforated
A = A5000 or AP = A5000 perforated
E4 = E4760 or E4P = E4760 perforated
A6 = A6200 or A6P = A6200 perforated |
Note: Data provided is for information only and does not constitute any warranty for the product. As the conditions and varying methods of use are beyond our control, Richmond Aircraft Products, Inc. shall not be liable for any special, indirect, incidental, or consequential damages, including without limitation, lost revenues or lost profits, which may result from the use, or inability to use these materials. These materials are provided "as is" without warranty of any kind, either expressed or implied, including, but not limited to the implied warranties of merchantability or fitness for a particular purpose. | 
