TECHNICAL DATA
VAC-PAK^® A6200
ETFE / Fluoropolymer Release Film

DESCRIPTION
VAC-PAK^® A6200 is an ETFE/fluropolymer release film, a low cost alternative to FEP, available in red or blue colors. VAC-PAK^® A6200 is a high temperature release film suitable for use up to 450°F (232°C) with good elongation properties.

APPLICATION
VAC-PAK^® A6200 has good elongation and can overcome bridging problems in complex contour lay-ups. The high temperature capabilities of VAC-PAK^® A6200 are compatible with most commonly used resin systems used in composites and adhesive bonding and will release easily after cure. VAC-PAK^® A6200 is blue, red or orange and easily identifiable against the part for removal and the color will not transfer.
VAC-PAK^® A6200 is available non-perforated or in the perforations shown in Table I in this section of our catalog.

MECHANICAL PROPERTIES TYPICAL VALUE
Tensile strength: > 6000 PSI 422 kg/cm²
Elongation: > 450%
Yield: 110 ft²/lb/mil 22.48m²/kg/25µ

THERMAL PROPERTIES °F / °C
Maximum use temperature: 450 / 232
Melt point (DSC): 500 / 260

VAC-PAK® A6200 red or blue is available in standard roll sizes at:

.001" x 60" x 417'
.025mm x 1.52m x 127m
.001" x 50" x 500'
.025mm x 1.52m x 152m

Other sizes are available.

VAC-PAK® is a Registered Trademark of Richmond Aircraft Products Inc.
Note: Data provided is for information only and does not constitute any warranty for the product. As the conditions and varying methods of use are beyond our control, Richmond Aircraft Products, Inc. shall not be liable for any special, indirect, incidental, or consequential damages, including without limitation, lost revenues or lost profits, which may result from the use, or inability to use these materials. These materials are provided "as is" without warranty of any kind, either expressed or implied, including, but not limited to the implied warranties of merchantability or fitness for a particular purpose.